The Shot rig

The shot rig is based on the idea that a heavy hookpoint will prick the carpīs mouth better and quicker than a light one. Thanks to the split shot which is attached next to the hookpoint the point quickly sinks in the carpīs mouth once sucked in and hooks the carp This is an advantage in particular on pressured waters where the carp have seen a variety of rigs and have been caught before. Many successful British carp anglers including Frank Warwick use the rig quite a lot. The best way to fish the rig is in conjunction with a pop up like the Fluro Pop ups from Dynamite Baits. These are very visible and attractive for the carp, hence the fish find them quickly. The size of the split shot should be chosen so that the hook and the bait slowly sink to the bottom. The bait should sit nicely on top of the lake bottom. With the aid of the following photos itīll be very easy for you to tie the rig yourself :

Photo 1 :   All you need for tying the rig; a soft braid like Fox Armadillo in 30 lbs, split shots, a lighter, a pair of scissors, some silicone tube and some shrink tube.

Photo 2 :   Tie the rig as usual with a line aligner. Cut off a piece of thin braid and lay a loop into the split shot .

Photo 3 :   Carefully thread the split shot onto the hook and close the it so that it can just about move freely on the hookshank without being able to slide over the barb.

Photo 4 :  With a lighter you can now burn the ends of the loop to lock the line in place. Afterwards you just have to attach a pop up that matches the weight of the hook and the split shot so that it sinks slowly. Due to the fact that there are so many different hooks and pop ups thereīs no general rule which size of hook and split shot matches a certain pop ups size but with a few tests with your own baits you can find out easily what split shot size and which pop up match so that the bait is critically balanced.

Photo 5 :  A nice carp caught using the Shot rig.

Keep catching !

Christian Finkelde

powered by motion-park.com