The majority of carp anglers nowadays uses
braided hooklength materials.
 |
The advantages of braided materials are
obvious; they are strong whilst having a comparatively
low diameter, plus they are far more supple than mono
lines. Due to this attribute a bait presented with a rig
tied with braided line behaves very natural under water
when a carp sucks the bait in; almost like a bait
without a hook.
But as easy as the carp can suck the
bait in , it can eject it, too. On waters where the
fish are pressured this happens very often.
A few years ago I could observe a group
of carp feeding in the margins on a water that was and
still is very heavily fished by carp anglers. I threw
in a couple of boilies about a meter away from where the
carp where feeding on the bottom in the shallow water
and hid behind a small bush to wait and see what would
happen. |
A few minutes
passed by and then one of the carp discovered the boilies I
had thrown in.
The other carp followed him a little
later.
In the clear water I could observe how the carp
sucked in the baits only to blow them back out again straight
away. This procedure continued a couple of times until the
carp was sure that this boilie wasn´t attached to a
hook.
I´m pretty convinced that if I had fished this
swim casting from the other bank towards the margins where the
fish were now feeding that I would have only got a single beep
or even no indication at all from my Micron RX.
On waters where the carp have already been
caught several times we often don´t recognize it when a carp
tests our hookbait by sucking it in and blowing it back out
again;
especially if one is fishing at long
range.
For this reason Stiff Rigs (rigs tied with
stiff mono line, especially the new fluorocarbon lines) are
very popular in England at the moment.
Fluorocarbon lines
have the advantage over standard mono lines that they are
heavier than water and thus sink very well plus they are very
difficult to see under water due to the fact that their
light refractive index is closer to that of water than
standard nylon.
But why mono or fluorocarbon lines some of you
will ask.
The idea behind the use of stiff hooklength
materials is that mono rigs are more difficult for the carp to
eject once it has sucked the hookbait in.
But now that
we´re using a stiff rig one also has the problem that the bait
doesn´t behave as natural under water as with braided
lines.
For this problem there are two solutions.
 |
The first one is the so called combi rig
, the second a so called stiff hinge rig . A
combi rig consists of a 15 – 20 cm long piece of mono
line to which one ties about 3 cm of braided material
near the hook. Due to the braided and supple material
near the hook the bait behaves natural under water but
then again it is difficult for the carp to eject the rig
due to the long stiff section of the rig.
The second alternative is to fish a mono
rig straight through but with a loop on the swivel or
better one of the new flexi –ring swivels which are now
sold by Rod Hutchinson, Fox and ESP. The loop or the
swivel (emerillon avec anneau) allows the hookbait to
move freely on the bottom of the lake, even though the
hooklength material is stiff.
|
Personally I prefer to
fish the second alternative (mono rig with flexi ring swivel)
as this rig never tangles and it always lies straight on the
bottom thus the hook is away from the lead.
Ideal are stiff mono materials with a diameter
of 0.40 mm or more.
During the last couple of years I´ve fished
quite a lot with this kind of rig and I´ve been very content
with it.
As stiff hooklength material I can recommend
three lines in particular. These are Illusion from Fox; Stiff
Stuff from Rod Hutchinson and Bristle Filament from
Drennan / ESP.
I tend to use breaking strains of 20 lbs and
more for two reasons.
Firstly, thicker lines are more
stiff than thinner ones which increases the stiff rig effect;
secondly , on snaggy waters lines with a diameter of
0.40 mm and more are safer.
A positive side effect of the Stiff Rig is
that one normally doesn´t have to use an anti tangle tubing
anymore.
 |
On waters with a lot of crayfish I
usually fish only stiff mono rigs (with mono hair, too)
as these can´t be tangled by the crayfish (ecrevisse)
.
Before I finish this article I`d like to
present you another version of the stiff rig which is
very popular in England at the moment. It´s called
the Spinner rig or the Terry Hearn Rig. It´s called
Spinner rig because the rig allows the hook and bait to
move and turn very freely.
The job of a rig is to present the
hookbait as natural as possible but it has of course to
be strong enough to allow the angler to land the hooked
carp.
An ideal presentation would be if the
hookbait behaves no different to the free
baits. |
I think if you take
a look at the drawing of the spinner rig you´ll see which
advantages it has got.
Due to the two stiff sections of the
rig the hookbait can move very freely on the bottom of
the
water.
Due to the fact that both parts of the rig are
stiff the rig always lies straight on the bottom once you´ve
cast out.
As soon as a fish picks up your hookbait it bolts
against the weight of the lead as the rig lies straight on the
bottom and thus the fish usually gets hooked very
well.
Tying the rig isn´t very difficult.
Firstly
attach your hook to the stiff line with a no -knot knot . Make
4 – 6 turns and leave a bit of line standing .
At this end
you can now tie the „D“ on the hook by pulling the
overstanding line back through the eye of the hook.
Once
the line is pulled back through the eye of the hook you can
cut it off (but not too short).
With the aid of a cigarette
lighter you can melt the line a bit which results in a nice
little blob that prevents the line from slipping back through
the eye of the hook. But be careful not to burn and weaken
your rig.
Tungsten putty for balancing the pop up can be
attached to the uni – link swivel in the middle of the
rig.
|
Terry Hearn uses this rig with pop ups
but it also works with sinking baits. The best way to
store your stiff rigs is to keep them straight on
a rig board or in a stiff rig pouch.
Finally I´d like to mention that I´m not
of the opinion that the stiff rig is necessary on all
waters. With this article I just wanted to present
you this kind of rig. If the rig is necessary
on your water or not is something you have to decide for
yourself. Personally I´ve tried the Spinner Rig but
generally I think it´s not necessary on most French
waters. |
 |
If
you ever have problems with false takes , which can have many
reasons, give the Stiff Rig a try.
Tight Lines !
Christian Finkelde