Along with a few mates I recently answered the question of how to
make mashed bread for chub fishing and the best way of using it.
|

|
|
Drying out in the
landing net |
I buy half a dozen loaves, break them into approximately 2ins
pieces, throw them in a landing net and hang it in my garage until
the bread dries out - not hard but crumbly.
I soak the bread overnight and then squeeze as much water out as
I can. It is then mashed by hand, but not too much, for that way
there will still be a number of lumps left in the mash. These will
be small hookbait samples trundling through the swim as the finer
mash gets caught in the current.
Very often I add a helping of hempseed to the mash, nothing
measured, just so that it looks liberally sprinkled with it. Then I
split into session sizes, usually about enough to fill a 3 pint
Drennan baitbox. This gives me enough for a 6 to 8 hour session. The
lot is then stowed in the freezer.
But remember to take a portion out the day before you intend
using it, for it can take several hours to thaw out
sufficiently.
|

|
|
Liquidised
bread |
Sometimes I push a few pieces of squeezed flake into the mash
when I'm at the waterside and a dose of trout micro-pellets. The
trout pellets are added at the last minute so that they stay
reasonably crisp and whole for the session. If they're added at the
same time as the hemp, prior to freezing, they end up soggy and part
of the mash. Of course, you could add a few pellets at that stage
and some more at the waterside and have the best of both worlds.
Then I feed it with a cage feeder and sometimes give them extra by
hand if they're well on.
FISHINGmagic writer Gary Knowles
added:
I do the same thing except that I also squirt some cheese
flavouring into it. When it's really cold and clear I use fresh
bread liquidised. This you can squeeze by hand without adding water,
ball it in (small pigeon egg sized) or through a small cage
feeder.
Dave Cooper our 'Purely For Pleasure'
author, says:
If you want much finer particles that break down into a real low
feed cloud, break down a loaf into breadcrumbs in the
liquidiser/food processor and then let the crumb go stale in a
bucket for a day or two. Add crushed hemp and then use 'as is'
without adding any water in a cage or open end feeder. Especially
good when there is little flow in the river as it explodes into a
fine cloud. Good for roach fishing too.
I find thick sliced bread works well with those Drennan punches
if you want a more resilient hookbait as it squeezes together more.
Use medium bread if you want a more fluffy texture. I haven't found
that cheap bread makes any difference to catches. My near '5' a
couple of weeks ago was caught using a Sainsbury's 19p economy
loaf.
|

|
|
ready for
mashing! |
Eddie Bibby said:
If you go to Kwik Save late on Saturdays they often have large
sliced loaves for about 10 or 15 pence each. Just dry them out and
they keep for ages.
Dave 'Chub' Johnson added:
Graham's method is spot on, plus you can add all sorts of
flavours to the liquid. I tend to use Graham's preparation when I am
using a cage feeder to get the mash into my swim.
However, for all round general bread work, I prefer to leave the
bread to go stale, and then feed it by rubbing half a slice between
the palms of my hands. This way you can control how big or small the
particles are.
|

|
|
You can add a
flavour |
|

|
|
Perfect
mash! |
I fish this method on smaller rivers where using a feeder would
spook the chub. You can add small balls of this rubbed up bread
accurately and quietly and it creates a wonderful trail /cloud as it
disperses and sinks.
I usually buy four or five loaves every week so that I have a
rolling stock of stale bread in the garage, and I f I don't use them
when they are reaching their 'ideal' state, dump them in the freezer
or make up a freezable
paste.